![]() Step 6: Now join both the pieces to check whether it makes a proper and exact cut or not.Step 5: Move the other piece of wood along the router bit this will give you the groove cut.Make sure that the router table is unplugged during changing the router bit. This will ensure that the cut is even all around without any defect. If you have further questions, please contact our Technical Support Department at. Make sure the bottom of the teeth goes parallel to the throat plate. You need to adjust the bit before starting to cut with it. Step 4: Now change the router bit and use another but for groove cut. Start by setting the bit into your router.I have the WL-1484 Tongue and Groove Router bit 'set'. If you have further questions, you may also call us M-F 8-4 Central Time at 80. Step 3: Now move the piece of wood along the bit with the supporting material. WL-1338B has a cut length of 1-1/8', so it will work on either the 7/8' or 3/4' material.Step 2: Place one bit for tongue cut in the router table and adjust the fence and we do in the previous method and fix the fence.One for tongue cut and the other for groove cut. Step 1: Take two pieces of tongue and groove bits.This method is similar to the previous method, the difference is that there was only one piece of bit and here, we use two bits separately. ![]() In this method, we will use both bits for tongue and groove cut. How to use two pieces of tongue and groove router bits? There are several router bit sets available for making divided-light. What size material are you using? Is it a squared joint or would you like a V in the groove? Do you need it to be adjustable? Will it be used for a rail & stile application, paneling or flooring? If it's for flooring, is it new or an existing replacement? If you have trouble deciding or have a special application, let us know and we can help. Plane the underside of the bottom tongue straight and smooth, and then sand it and. Groove router bits seem like they should be pretty straightforward, but there are a multitude of variables to consider.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |